Transceivers General Purpose 900 MHz./2.4GHz.  Develops frequency hopping spread spectrum wireless data telemetry solutions. We provide low cost 900 MHz and 2.4 GHz wireless modem modules and stand-alone radios for OEMs

Transceivers General Purpose 900 MHz./2.4GHz. Spread Spectrum Frequency Hopping Transceivers Main Features LED power and configuration activity indicator Astron AXH900RP SMA R Reverse Polarity SMA 6.5” Antenna High Impact ABS enclosure Channel Capacity hops through 25 channels, Up to 65,000 NetIDs Serial Data Interface Asynchronous (RS-232) CMOS (TTL) signals, 5V, 3.3V tolerant I/O Data Rate - 9600 or 19200 bps Transport Protocol - Transparent networking Network Topology - Multi-drop Channel Data Rate - 10k or 20k bps respectively (vary with data rate) Transmit Power Output - 100mW Rx Sensitivity: -110 or -107 respectively Range - Indoor: 600’ to 1300’ Outdoor: 7mi. with dipole, >20mi. with high gain antenna Interference Rejection - 70 dB at pager and cellular phone frequencies Description: The GC Transceiver is a general purpose compact data transceiver perfect for those needing high performance and dependable operation. It’s wireless modem transfers data at 9600 or 19200 baud up to � mile in a city environment or greater than 10 miles line-of-sight with a directional antenna. It is ideally suited for applications in supervisory control and data acquisition (SCADA), remote meter reading, home automation, security, instrument monitoring, point of sale systems (POS) and myriad other applications. Transceiver modules have built-in support for multi-drop networking protocols. Multiple independent networks can operate in the same vicinity by using distinct network identifiers. The radios integrate quickly and seamlessly into any new or existing design. Simply output serial data from an microcontroller or RS-232 port into the radio to send FCC approved, frequency hopping spread spectrum data through the air and capture it on all receivers within range on the same network. The system behaves as a virtual half-duplex parallel-wired network.

Technical Features:   GENERAL Model TZR Frequency Range 900 MHz. / 2.4 GHz., unlicensed ISM Band Type Frequency Hopping Spread Spectrum Transceiver Frequency Control Direct FM Transport Protocol Various Monitoring and Addressing Modes Channel Capacity Hops through 25 channels. Features 7 diff. hop sequences. 65,000 network identifiers. Serial Data Interface Asynchronous CMOS (TTL) signals, 5V levels Serial Interface Baud Rate Configurable from 2400-57600 bps Data Throughput 9600 bps Network Topology Point – multipoint, point-to-point multi-drop transparent networking PERFORMANCE - Channel Data Rate 10k Transmit Power Output 100mW Rx Sensitivity -110dBm Range* Indoor: 600’ to 1500’ Outdoor: 7 mi. with dipole, over 20 mi. with high gain antenna Interface Rejection 70 dB at pager and cellular phone frequencies

IQUPS If you are a systems integrator, installer, engineering procurement contractor or an electrical contractor

We will work with you to design a Solar - Fuel Cell and or Wind power system for your project some applications Business - On-Grid Commercial Buildings and Off-Grid Industrial Remote electricity anytime anywhere!.

Businesses - Government Agencies and homeowners around the world are using OkSolar systems Integrated systems Solar, fuel Cells and wind energy.

Applications: Commercial - Industrial - Disaster Relief - Military and Residential AirportIQ UPS Airfield Power Backup Electrical

Communication infrastructure(Local and Federal Government)

Base Stations for Mobil Networks that can run on Solar, Wind and Fuel Cells.IQ UPS Base stations cut diesel usage by 75 percent. IQUPS.com has designed a base station for mobile networks that would run on sun, wind power and fuel cells. Gas Stations (Powering gasoline pumps during a power failure).

Hospital EMS: IQ UPS Hospital Power Backup Electrical ( Emergency Power Back-up for Hospitals ).

Rail Roads: Railroad crossing signals backup.

Traffic intersections: backup power for critical LED traffic light intersections.

Solar Trees Arrays We Delivered On-Site For Fast Plug and Pay Installation Solar Tree structure are designed for the following applications: Shading vehicles from the sun and at the same time generate Green energy. Facilitate the creation of infrastructure for electric vehicles.

Traffic Application: -Keeping Traffic Moving When The Power Goes Out Item#1608450 Portable Solar Powered 120 volts 60Hz. or 230 Volts 50 Hz, Portable Solar Powered 220 Volts 50 Hz, Portable Solar Powered 230V 50Hz, Portable Solar Powered 220Volts 50Hz pedestrian signals, A 120 or 240 V, 100 amp, single-phase IQUPS.com transfer panel is used to activate the generator at the loss of power. According to IQUPS, the generator assumes the full load in seven seconds. When utility power is restored, the generator shuts off and signal operation is automatically returned to the normal power source. "The IQUPS1800 will completely run the intersection stoplights," said general manager for the DOT. "Other backup systems will put the lights to flashing red. When the generator kicks in on the IQUPS1800, the lights will fully function for 25 to 40 hours, depending on the load at the intersection. When power is restored, the system returns to utility power and the traffic signals do not need to be reset." Battery Backups Prevent Accidents at Critical Traffic Signals Additional Applications Being Taken for More Intersections Keeping Traffic Moving When The Power Goes Out Portable Solar Power 120 Volts 60 Hz or 230 Volts 50Hz, Traffic Portable Solar Power 120 Volts 60 Hz Thanks to new IQTraffiControl.com energy-efficiency technology, different Cities, towns and counties will keep their traffic signals safely operating even if the electricity goes out, and other local governments. Intersections have been converted to new LED signal lights utilizing more efficient, LED (light emitting diode) lamps. The new lamps cut the amount of electricity used by each light from as much as 150 watts to between 10 to 25 watts. Because LEDs use so much less electricity, it is now technically possible to provide battery backup power to alike. We also Have Fuel Cells Traffic Backups.

IQ UPS Traffic Back-up Standby Power Generation. - Battery backup systems for LED traffic Signs -

IQUPS Battery Backups Prevent Accidents at Critical Traffic Signals Increase the public safety and reduced traffic congestion by allowing traffic lights to function even during a power failure. A typical traffic signal intersection experiences eight to ten local power outages annually. With battery backup 3 power, some or all the traffic control signals can continue to operate. This seamless switchover to battery power increases public safety and eliminates the need to dispatch police or other service personnel to direct traffic. If all traffic signals were converted to LEDs, the battery backup system would allow full operation of the traffic signals during a power outage, thus alleviating traffic congestion.

Sample Ready to ship unit

Note: To view the above PDF documents, you will need the free Adobe Acrobat Reader
 

Develops frequency hopping spread spectrum wireless data telemetry solutions. We provide low cost 900 MHz and 2.4 GHz wireless modem modules and stand-alone radios for OEMs !